KNX/EIB
Switch Actuator with Secure
54
5.2.7. Forced function object “Switch actuator"
Fig. 5.2.7 Forced function communication object “Switch Actuator”
No.
Function
Object name
Data type
Flags
DPT
17
Forced operation
Output A-{{...}} 1bit
C,W
1.003 enable
This object will be started after enabling the 1bit forced function. Enable the forced function with
“1”, and the other behaviors will be ignored except the forced function; enable the forced function with
“0”.
17
Forced operation
Output A-{{...}} 2bit
C,W
2.001 switch control
This object will be started after enabling the 2bit forced function. The contact is forcibly closed
when the message value "3" is received; The contact is forcibly disconnected when the message value
"2" is received; the enforcement mode is canceled when the message value "1" or "0" is received.
Table 5.2.7 Forced function communication objects
