KNX/EIB
KNX Gateway for IR
18
——Parameter “Swing”
This parameter is visible when enable swing control. Set the action of swing when power on.
Options:
Swing
Stop
Parameter “Object datatype of setpoint temperature”
This parameter is for setting object datatype of setpoint temperature. Options:
1byte (real temperature value)
2byte (knx standard DPT)
Parameter “Min. setpoint temperature”
Parameter “Max. setpoint temperature”
These two parameters are for setting the adjustable range for limiting the temperature setpoint
value. The minimum value must be less than the maximum value. If the setpoint value exceeds the
limited range, output according to the limit. Options:
16°C
17°C
...
30°C
Parameter “Emitting AC status after bus recovery”
This parameter is for setting whether to send the command of Air-condition control to the device
after bus reset. Options:
No
On
Off
As before power off
No: no emission;
On: emit the IR code when power on Air-condition;
Off: emit the IR code when power off Air-condition;
As before power off: emit the IR code of the Air-condition status as before power off.
