KNX/EIB
KNX Gateway for IR
29
6.2 “Universal IR code control” communication object
Fig.6.2 “Universal IR code control” communication object
NO.
Object Function
Name
Data Type Flag
DPT
18
IR Control trigger value
CH1-{{IR control 1}}: Input
1bit
1byte
C,W,U
1.001 switch
5.010 counter pulses
This communication object is used to receive trigger value of IR code. Object datatype and trigger
telegram are both set by parameter.
The name in parentheses{{}} changes with the parameter “Description (max 30 char.)”. If
description is empty, display “...IR control x...” by default, such as “CH1-IR control 1: Input”. Below is
the same.
19
IR Response value
CH1-{{IR control 1}}: Status
1bit
1byte
C,R,T
1.001 switch
5.010 counter pulses
This communication object is used to reply a status value to the bus after the device sending IR
code, to inform emission is completed.
Responding control value is set by parameter, object datatype is the same as trigger value’s.
Table 6.2 “Universal IR code control” communication object
6.3 “Air-condition control” communication object
Fig.6.3 “Air-condition control” communication object
