2
4. Installing the sanding paper
(1) Bending the sanding paper:
Position the sander with its pad side facing upward
as shown in Fig. 1. Place the sanding paper on the
pad so that the center of the sanding paper is aligned
with the center of the pad, and bend both ends of the
sanding paper at a 90° angle. Then, bend both ends
again in the manner shown in Fig. 2. The sanding
paper is now ready to be installed on the sander.
(2) Installing the sanding paper:
While ensuring that the cord is not bent, place the
sander on a workbench as shown in Fig. 3, and insert
one end of the sanding paper (bent section). Next,
insert the remaining bent section in the same manner.
*Be sure to check the nameplate on product as it is subject to change by areas.
SPECIFICATIONS
Voltage (by areas)*
(110V, 120V, 220V, 230V, 240V)
Power Input
200W*
No-load speed
14000 min
–1
Sanding pad size
110 mm
×
100 mm
Sanding paper size
114 mm
×
140 mm
Weight (without cord)
1.1 kg
STANDARD ACCESSORIES
䡬
Sanding paper ............................................................ 1
䡬
Dust bag ...................................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Sanding paper
䡬
114
×
140 mm paper clip type sanding paper
Grain: AA60, AA100, AA150
䡬
110
×
100 mm Velcro type sanding paper
Grain: AA60, AA100, AA150
䡬
110
×
100 mm stick-on type sanding paper
Grain: AA60, AA80, AA100, AA120, AA150, AA180
䡬
Outer diameter 125 mm stick-on type sanding paper
Grain: AA60
2. Sanding pad
䡬
110
×
100 mm sponge pad (Velcro type)
䡬
110
×
100 mm stick-on pad
䡬
Outer diameter 125 mm stick-on pad
3. Punch plate
Optional accessories are subject to change without notice.
APPLICATIONS
䡬
Finish polishing of woodwork surfaces
䡬
Sanding surfaces of woodwork or sheet metal prior
to painting, etc.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF positon. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
Fig. 1
Sanding
paper
Fig. 2
Fig. 3
Sanding paper
Sanding paper
Summary of Contents for ESP110
Page 7: ...6 ...
