Operating instructions K-Laser Blue Dental Rev. ZE
Page 39 of 72
In
Manual
area the device allows to select the optic to be used.
After selection, the device displays the following screen.
Ten different levels of the red aiming beam can
be defined.
Graphic of the laser impulse.
Wavelength selector. Press it to select needed
wavelengths, in individual or combined way.
ISB modality. It is on if the green bar is present.
Number of impulses or emissive time in seconds.
Number of the impulses or emission time.
Press to increase or decrease the numerical value.
Press it to go back one screen.
Laser armed. After a delay of 2 seconds by this button
pressure, the aiming beam is switched on and the laser
is ready to be used.
Press it to save a treatment.
Notice
In all the no contact tip the CW modality is not available.
The device will automatically define the following parameters:
The device calculates the energy delivered according to selected
power and time.
The device shows the energy emitted during treatment.
The duty cycle is defined as the ratio between the pulse duration
(when the laser beam is actually actuated) and the total period of
time (which is the time from the beginning of a pulse to the
beginning of the next pulse).
The device calculates the frequency of the impulse based on the
Ton
– Toff by the operator.
Frequency (Hz)
Energy
Applied
Duty Cycle (%)
