Operating instructions K-Laser Blue Dental Rev. ZE
Page 61 of 72
7.4 Cleaning of the handpiece for therapy
Warning
Before cleaning, switch off the device and disconnect the power cable from the power supply.
Caution
Prevent dust, dirt and foreign particles from entering the handpiece.
Make sure that the optic system is always cleaned: before, during and after the use.
Caution
Always cover the connectors with the special protective caps provided for this purpose after the
removal of the handpiece.
Clean the optic with a dry, soft cloth to remove dust from the handpiece. More stubborn spots can
be removed with a damp cloth.
Notice
In the event of dirty spots on the external lens use a cotton bud to clean it, taking care not to
extremely press the optic part. More stubborn spots can be removed with a proper lens
cleaner. Wait the complete evaporation of the detergent before using the handpiece.
You can disinfect it using any of the products that are commonly used to disinfect medical electrical
equipment, e.g. MinutenWipes from Alpro and Caviwipes TM.
Observe the instructions provided by the manufacturers of these disinfectants.
Notice
Use only disinfectants that comply with the requirements of your national authorities and whose
bactericidal, fungicidal and virucidal properties have been tested and properly certified.
Notice
Clean the optic with a dry, soft cloth to remove dust from the lens that preserve the optics.
More stubborn spots can be removed with a damp cloth. Please proceed carefully not to
scratch and damage the lens.
