1.
Make sure the flashlight is switched off.
2.
Unscrew and remove the back cover from the flashlight.
3.
Insert the batteries into the adapter and then into the plastic holder. (Only
when using non-rechargeable alkaline batteries).
4.
Install the K-NATICS ULTRA battery with the positive (+ pole) towards the
lamp head and the negative (- pole) towards the screw cap on the back).
5.
Screw the back cover onto the flashlight and switch the flashlight on.
1.
Advanced Focus System
The flashlight is equipped with an Advanced Focus System (zoom function).
This makes it possible to adjust the light's circumference (and therefore the
light intensity) in order to see well both near and far. You do this by simply
sliding the top of the light in and out.
2.
Different light modes
In addition to the zoom function, the flashlight is equipped with 5 different light
modes: High, Medium, Low, Strobe and SOS.
Press the on/off button once to switch on the flashlight.
After the flashlight has been switched on, short press the on/off button to
switch between the different light modes in the order:
HIGH - MEDIUM - LOW
–
OFF
.
Hold the on/off button for 3 seconds to switch on the
strobe
.
Press the on/off button twice in quick succession to activate the
SOS function
.
When the torch has been switched on for more than 7 seconds, it will switch
off immediately with one push on the on/off button.
For longer battery life, it is recommended not to use the torch continuously at
its highest light setting.
3.
Charging
The flashlight can be charged using the USB-C cable. The USB input is placed
in the middle of the torch and is closed with a rubber cap. For example, charge
the torch via a laptop or powerbank. The charging time of the battery is
approximately 5 hours.
9.
Battery installation
10.
Using the flashlight
