Guidelines for Installing Interactive Whiteboard 600i system with K.O.H. Rail
system
Proceed to Installation
(continued from page 2)
3. Measure 3 ¼” from the top of the SMART board’s frame and mark it, this marks the
bottom where the KOH mounting block will be positioned/installed.
4. Position the bottom of KOH mounting block at the 3 ¼” mark, and mark off the 2
pre drilled holes to the sides of the center holes (center holes are used for mounting to
the stud).
5. Drill holes in the wall for the 2 holes on the side.
6. Securely attach the KOH mounting block to the wall. Use the center holes to secure
to the stud, use dry wall anchors for the side holes (screws & anchors supplied).
7. Securely attach SMART’s “mounting plate” to the KOH mounting block with
8. Proceed using SMART’s regular instructions for the 600i system.
page 3 of 3 K.O.H. installation manual for SMART 600i
the five (5) enclosed screws.
