K-Stove® is a brand of DMS-Europe BV
NL-3641AR-2 The Netherlands
15
!! ATTENTION !!
During the flame switching off phase and exchanger cooling, Normally it isn’t allowed to switch on again
the heater up to the operation end; this state is highlighted from the message
‘SWITCHING OFF’
HOWEVER,
It is possible to switch off the heater in every functioning phase. The switching off performs
pressing the key ON/OFF
for two seconds,
make sure the stove is under your eyes
, until its
“Stabilisation”, After push the button, then the phrase "Cooling" comes
After the stove’s temperature falling down, the stove starts again, Cleaning-feeding-lighting-stabilization.
-------------------------------------------------------------------------------------------------------------------
How to make the stove immediately skip the process to Stabilization During the first several stages when you
think the flame is ok and/or the stove can work properly?
Push
for 3 seconds, and then it will turn on Stabilization directly.
!! ATTENTION !!
If the heater is switched off, the flame will continue to be present up to the fuel exhaustion contained in the
melting pot, this phase will manage in automatic way both fans and it will have the duration up to 5-8
minutes.
The switching off phase is displayed from the message ‘SWITCHING OFF” present up to the
end of the operation.
Whether the heater is switched or not, on the display will display the hour, the power, and the
planned set temperature.
Note: If the new stove, when its first time using, it is necessary to put a hand of pellet to the fire pot
before hand.
