4. USAGE
14
Kilobot User Manual
4.2.3 Overhead Controller (OHC) Hardware Installation
1.
Check that the firmware jumper is plugged at the correct place (figure 4.6).
2.
Connect the USB cable to the PC; the power LED of the OHC should turn green.
3.
Run the “kilogui.exe” program, the message “connected” must appears at the bottom of
the windows:
4.
Press the “LedToggle” button to validate the communication (a Green LED on the OHC
must change its state at each pressing).
5.
If the message “connected” didn’t appear, please follow the steps in chapter 4.2.2.1
Summary of Contents for KILOBOT
