10
DDS CLOSED CARTRIDGE DAMPING SYSTEM
With one person on each
handlebar slowly lift the bike and
support the bike under the
bottom fork clamp
so the wheel
is off the ground. Refit the top
caps to the fork legs and torque
load to 10N/M
(7.35 Ib-ft)
- using Tool No. 113-020-000.
13.
CHANGING THE FORK SPRINGS
Tighten the upper fork clamp
bolt to manufacturer’s
specification and adjust
preload and damping
settings to previous or
recommended settings.
(Located at the front of document)
14.
K-Tech Suspension Ltd recommend that this product is serviced every 20
hours of use. It is very important that this product is serviced by an authorised
dealer, as there are special tools required to guarantee correct performance
of this product. K-Tech Suspension Ltd cannot be held responsible for any
damage caused to/by the product if a service is overdue or was not conduct-
ed by an authorised dealer.
www.ktechsuspension.com/service-centres-and-partners
SERVICE
