2
INSTRUCTIONS FOR USE
We recommend using this machine after reading the instruction manual carefully, keeping to the
instructions provided therein.
1. Do not exceed 800 lb load
2. Use lifting accessories suitable for the load to be supported and complying with ASME standards
3. Use bolts equal to or higher than class 4.8
4. Tighten the bolts and make sure that the weight is suitably held
5. Make sure that the points of support are suitable for the weight to carry
6. Do not use while the engine is running
7. Check the state of the support before using it; replace it if irreparable damage has been caused
8. Do not modify the product; do not weld it in any way
9. Failure to follow the above rules may result in severe damage or injury
The tool is designed to support the engine, while removing its supports from the vehicle, using struts to carry
its weight.
We recommend not keeping the engine running or starting the engine with the mounted bracket.
Pack contents:
– 1 bracket
– 2 chains, 3.15 ft
– 2 supports with rubber guards
– 2 hooks that can be vertically adjusted through threaded nuts
Use:
Assemble the tool; place it on the vehicle, leaning the brackets with the rubber guards on the suspension
struts.
Connect the engine to the bracket, making sure that the chosen point can carry the weight, using the chains
supplied with the tool. If these should not be sufficient or adequate enough, use lifting accessories, including
hooks, eyebolts and eye nuts, certified for the load to be supported.
