STANDARDS AND GENERAL WARNINGS
11
1.8 ORDERING OF SPARE PARTS
Orders of spare parts should be made by consulting the part reference code and the serial
number of your unit. Consult your dealer.
1.9 PRODUCT CONFIGURATION
The unit is designed solely for the preservation of laboratory products, which requires
various controls and warning in case of sudden alteration of temperature.
PRODUCTS MUST BE STORED IN ORDER TO ENSURE EFFICIENT AIR
CIRCULATION INSIDE THE UNIT AND SHALL NOT COME OUT OF THE
SHELF/DRAWER PERIMETER.
All uses outside of manufacturer’s intended use in section 1.1 shall be construed as
“improper use” for which the manufacturer declines all responsibility.
It’s allowed to accommodate on the shelf a maximum of 20kg per shelf in according to the
UL471
regulation. [
The most critical application in terms of weight (glass door/ stainless
steel) has been tested following the Base standard UL 61010-1.The application can contain
a maximum of 15 shelve.
1.10 MATERIALS AND REFRIGERANTS
Materials in contact or potentially in contact with products are in compliance with the
relevant directives. The equipments designed and built so that contact parts can be cleaned
before each use. The refrigerants utilized comply with established regulations.
1.11 WARNING LABELS
Electrical Shock
LABEL A
Use of this equipment involves power supplies which convert line
voltage to low voltage power. Do not modify or use power supplies
other than OEM equipment. Connection of the power supply may
require a properly grounded receptacle. Potential for electrical
shock or equipment damage exists if precautions are not followed.
Hot Surface
LABEL B
Avoid contact with the hot surfaces potential for skin’s burns.
Cold Surface
LABEL C
Avoid contact with cold freezer surfaces potential for cold burns or
skin sticking to cold surfaces.
Safety Alert
LABEL D
