Figure 2
IIII. Operation
A. Installation
1. Slide case lock to the left to unlock (5).
2. Pull Powerwrap3 case (1) and power source (2) apart.
3. Slide iPhone® (7) into Powerwrap3 case (1).
4. Attach power source (2) to enclose phone.
5. Slide case lock to the right to lock (5).
B. Charging iPhone® 3G/3GS using Powerwrap3 case
1. Press and hold On/Off switch (4) for three seconds to activate phone charge.
2. Press and hold On/Off switch (4) when iPhone® is charged.
3. Press and hold On/Off switch (4) quickly to indicate the remaining capacity of the built-in battery in battery case.
C. Charging Powerwrap3 Protective Case
1. Connect the USB power cable to any computer, Powerock or Powerbar to begin charging.
2. Charge until the LED indicators (3) read full.
D. Charging your Powerwrap3 and iPhone® at the same time
1. Connect your Powerwrap3 protective case (iPhone® already installed) to the USB power cable.
2. Connect the USB power cable to any USB power source such as computer, Powerock or Powerbar to begin
charging .
3. Charge until the LED indicators (3) read full.
