L
ASER
L.E.D. L
IGHT
1. For best visibility, choose a mounting location for the laser L.E.D.
as close to the vehicle gauges as possible. See diagram A1.
2. Check for proper clearance behind the area where the L.E.D.
will be installed (approximately 1”), and drill a 3/16” hole in the
chosen location. See diagram A2.
3. Route the L.E.D. wires under the dash per diagram A3 and
connect according to the appropriate block diagram.
D
IAGRAM
C1
F
RONT
L
ASER
D
EFUSER
P
LUS
L
ICENSE
P
LATE
M
OUNT
1. Remove the mounting bolts and any existing frame or
cover from the license plate. Remove license plate.
See diagram C1.
FACTORY LICENSE
PLATE BOLTS
Note: When integrating the Laser DefuserPlus with the K40 remote radar system, the Laser DefuserPlus
will utilize the same warning light/speaker(s) as the K40 remote. Therefore, you will not
need to install the red L.E.D. alert light or piezo beeper that come with the Laser DefuserPlus.
1"
D
IAGRAM
A1
D
IAGRAM
A2
D
IAGRAM
A3
ALERT
LIGHT
RED ALERT L.E.D.
GREY L.E.D.
WIRE
BLACK L.E.D.
WIRE
P
IEZO
B
EEPER
1. For maximum audio output and concealment, mount the
piezo beeper in the driver’s left air vent. See diagram B1.
2. Use the supplied double stick “O” ring tape
to mount the piezo beeper.
3. Route the piezo beeper wires through or under the dash
per diagram B1 and connect according to the appropriate
block diagram.
D
IAGRAM
B1
PIEZO
BEEPER
LEFT AIR
VENT
RED WIRE
BLACK WIRE