10
Mark to Alert
The
Mark to Alert
function allows you to add specific GPS locations
to your personal database, alerting you to any point of interest you
choose (such as school zones, speed traps, or red light cameras).
•
Press and release
on the remote control when you want to
mark a location for alert.
•
Voice will announce, “Marked to Alert.”
In the future, you will be alerted as follows:
When you arrive…
You will hear…
…within a radius of 750 feet
...“Approaching marked location”
of a marked location
and the alert light(s) will flash twice
...at a marked location
...a single “Bing” tone and the alert
light(s) will flash once
MA
To remove a previously marked location from your database:
•
Press and release
while in the marked location.
•
Voice announces, “Marked Location Removed.”
To remove
all
stored locations:
•
Press and hold
for 5 seconds at any time.
•
Voice announces, “All Alert Locations Cleared.”
MA
MA
Speed Monitor
The
Speed Monitor
function alerts the driver when a preselected
speed is exceeded. Speed Monitor can be set to any speed between
40-100 mph in 5 mph increments or 60-160 kph in 10 kph incre-
ments.
The factory default setting for Speed Monitor is “Off.”
