Drill holes according to the installation
template, and put the mortise lock inside
the door.
Install the connecting screw bolt and fix
it on the outside escutcheon, put the
pressure spring and square shaft into
the hold.
Put the square shaft into the hole of
inside escutcheon.
Install batteries, battery cover, bottom
cover and strike plate.
Check if all functions are working
well, then installation is completed.
Put connecting cable through the
door, insert the shaft into hole on
mortise lock, and keep the outside
escutcheon
close to the
door, then fix
the inside
mounting
plate with
screws.
Insert the connecting cable and lock
case cable into the port on inside
escutcheon, then insert the shaft
of inside escutcheon into the hole on
the mortise
lock and keep
escutcheon
close to the
door, finally
fix two screws
from inside
escutcheon.
Fix mortise screws.
Note: Please make sure the dead bolt is inside of
mortise lock during
Note: Select the square shafts and screw bolts with
proper length according to door thickness range.
Screw bolt
Screw bolt
Square shaft
Square shaft
The bigger end
is downward
Connecting cable port
Battery cover
Bottom cover
Installation
Note: After installing the striker assembly, please check if
the lock works smoothly by opening/closing door.
Note: Test if mechanical key works smoothly after
installation.
