W W W . K A A R T A . C O M
1 7
U S I N G C O N T O U R O U T O F T H E B O X
B E F O R E Y O U B E G I N M A P P I N G
Contour software is already installed and configured to operate out of the box, which allows
you to start scanning immediately. If shipped in the United States, the battery is charged to
approximately 30%. Begin by charging the battery with the AC charger while you get familiar
with Contour operations. It takes approximately
one hour
to fully charge the scanner.
C o n t o u r U s e r A c c o u n t
Contour runs on the Ubuntu Linux Operating System. The user account is
contour_user
with
password
contour
. The device comes set up to automatically log in without a password and
opens the user interface at boot up.
S e r i a l N u m b e r
Your Contour Serial Number can be found under the
USB 3.0 and USB port cover
, located
along the right rear side of Contour (Figure 1). See Back of Contour diagram for guidance
in locating the port cover. The Serial Number is also located under the battery cover, in the
underside of Contour. To open the battery cover, gently place Contour on a hard surface,
with the screen facing down. Carefully remove the battery cover with a 2mm allen wrench.
Remove the battery from the chamber to reveal the Serial Number.
Figure 1: Serial Number locations (1) under USB 3.0 and USB port cover and (2) in battery chamber.
A copy of your Contour Serial Number is also provided on the Kaarta
Official Registration
Card
, which was shipped with your device. For more details, please see the Registration
section of this manual.
1
2
