W W W . K A A R T A . C O M
1 1
Figure 10: Upper Vehicle Mount Assembly operational support arm deployment.
6.
Tighten all eight (8) of the M5 flat head fasteners in the pivot joints just enough to
still allow rotation of the arms on the pivots with some resistance. Ensure that the
M5 adapter plate in each pivot joint is fully seated while tightening fasteners. See
Figure 10.
7.
Orient the Upper Vehicle Mount assembly as shown in Figure 11. Place the Upper
Vehicle Mount Assembly onto the Vehicle Mount Base Assembly. Extend each Upper
Support Arm until it contacts the set screw stop at each corner. Using a 6mm hex
allen key, install the four (4) M8 socket head fasteners, split lockwashers, and flat
washers that secure the Upper Vehicle Mount Assembly to the Vehicle Mount Base
Assembly. Tighten M8 socket head fasteners evenly in a diagonal pattern (corner to
corner) until the M8 split lockwashers have been flattened (Figure 11).
UPPER VEHICLE
MOUNT ASSEMBLY
M5 X 10MM LONG FLAT
HEAD SCREW (8X)
UPPER SUPPORT ARM (4X)
M5 ADAPTER PLATE (8X)