W W W . K A A R T A . C O M
1 3
S T O W A G E P R O C E D U R E F O R S H I P P I N G / T R A N S P O R T
S t e p 1 : R e m o v e U p p e r V e h i c l e M o u n t A s s e m b l y
1.
Using a 6mm hex allen key, remove four (4) M8 x 16mm long socket head
fasteners, split lockwashers, and flat washers that secure the Upper Vehicle Mount
Assembly to the Vehicle Mount Base Assembly as shown in Figure 12. Set the four
(4) M8 fasteners, split lockwashers, and flat washers aside.
Figure 12: Upper Vehicle Mount Assembly removal.
2.
Remove the Upper Vehicle Mount Assembly from the Vehicle Mount Base Assembly
and set aside. Re-install the four (4) M8 x 16mm long fasteners, split lockwashers,
and flat washers back into the four (4) M8 T-nuts in the Vehicle Mount Base
Assembly and tighten until the M8 fasteners bottom out in the frame as shown in
Figure 13.
UPPER VEHICLE
MOUNT ASSEMBLY
VEHICLE MOUNT
BASE ASSEMBLY
M8 HARDWARE (4X)
