6
G
ETTING
S
TARTED
To test successful installation of the lock before you begin lock set up,
perform the following operation.
Open Lock/Container Using the Pre-Set PIN
Your lock has been shipped pre-set so that any pair of numbers (except
“00”) followed by the factory PIN “502550” will open the lock.
Practice opening the lock several times before you set a new combination.
To open the lock using the pre-set PIN, complete the following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions. Simultaneous green and red
flashes display and two beeps sound to indicate that the lock is
powered.
2.
If this is a Spindled version of the lock, position the lock dial to the
HOME
position (i.e., the lip of the dial will cover the red “open lock”
indicator).
3.
Enter any two-digit number (except “00”) followed by the pre-set PIN
502550
on the keypad. If the combination is entered successfully, the
lock will respond as follows to indicate that the lock is ready to open:
Spindled PowerStar
- 1 slow green flash
Spindled PowerSaver
- Continuous green flashes for approx. 5
seconds
Non-Spindled PowerStar
- Continuous green flashes for approx. 5
seconds
Non-Spindled PowerSaver
- Continuous green flashes for approx. 5
seconds
4.
For a
Spindled
version of the lock, dial right (clockwise) until the lock
bolt is retracted and then open the container. If you have a
Spring
Bolt
, you must dial right and hold the dial until the container has been
opened so that the bolt does not “spring” back into the extended
position. For a
Non-Spindled
version of the lock, rotate the container
handle while the green light is flashing to retract the bolt and open the
container simultaneously.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
