7
Note:
The lock will not open if excessive force is applied to the end
or side of the bolt.
The installer should check for these condi-
tions during installation.
Close the Lock/Container
How the lock and container are closed is dependent on whether the lock is
Spindled or Non-Spindled and also on the type of bolt that is installed .
Spindled Locks:
For a
Standard Deadbolt
close the container and then lock the lock by
dialing left (counter-clockwise) to extend the bolt.
For a
Snap Bolt
close the container and extend the container boltworks to
the locked position. The lock bolt will automatically lock in conjunction with
the boltworks.
For a
Spring Bolt
close the container. The lock will automatically lock.
Non-Spindled Locks:
For a
Slide Bolt
close the container and extend the container boltworks to
the locked position. The lock bolt will automatically lock in conjunction with
the boltworks.
When you feel comfortable opening and closing the lock using the pre-set
PIN, you are ready to put the lock into operation.
Set Super Master User PIN
The lock is shipped with a default factory Super Master User PIN that can
be set (i.e., changed) by the Master User when the lock is in factory or
shelved mode. Once the Super Master User PIN is set, the Super Master
User combination can be used to shelve the lock in the event that the
Master User combination is lost.
Warning:
The setting of the Super Master User PIN is optional,
however, if you do not set the Super Master User PIN at this
time, all Super Master User capabilities will be permanently
lost.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
