27
Lock
Enter 01 to Limit
Enter 02 to Limit
Model
Reporting Capabilities to
Reporting Capabilities to
100, 200
All lock personnel
User IDs 00-03 only
400, 500
All lock personnel
User IDs 00-05 only
To change the reporting capabilities of lock personnel, complete the
following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Press
Enter
,
Enter
again and then
1
. Simultaneous green and red
flashes display.
3.
Enter the Master User combination. Simultaneous green and red
flashes display.
4.
Enter
01
to enable all lock personnel to retrieve reporting information
from the lock or enter
02
to allow only certain User IDs (see above
chart) to retrieve reporting information. Simultaneous green and red
flashes display.
5.
Enter the two-digit number you entered in Step 4 again for verification.
Simultaneous green and red flashes display.
Add Supervisor(s) or User(s)
Note:
A Master User can add a User to the lock (in Independent
mode) or can add a Supervisor to the lock (in Supervisory/
Subordinate mode). A Supervisor can add a User to the lock
(in Supervisory/Subordinate mode). In Supervisory/Subordi-
nate mode, Subordinate Users will be assigned to the Super-
visor who added them.
The maximum number of users that the lock will accommodate varies
according to lock model, each user having a unique combination. Refer to
the “Lock Models” section on page 1 for detailed information on the
maximum number of users.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
