28
To add a Supervisor or User to the lock, complete the following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Press
Enter
and then
3
. Simultaneous green and red flashes display.
3.
Enter the Master User combination or Supervisor combination.
Simultaneous green and red flashes display.
4.
Enter the new User or Supervisor ID. Simultaneous green and red
flashes display.
Note:
When operating in Supervisory/Subordinate mode, keep in mind
for the Auditcon 100 that User ID 01 is reserved for a Supervisor.
For the Auditcon 200, User IDs 01 through 03 are reserved for
Supervisors. For the Auditcon 400 or 500, User IDs 01 through
05 are reserved for Supervisors.
5.
Enter the new User or Supervisor ID again for verification. Simulta-
neous green and red flashes display.
6.
If additional Users or Supervisors are to be added, repeat Steps 4-5
until all Users/Supervisors have been added.
7.
Enter
00
. Simultaneous green and red flashes display.
Note:
The default PIN assigned to a new User or Supervisor ID is
“502550”. A user must change this default PIN before any lock
operations can be performed. Refer to the “Change PIN” section
for instructions on changing a User PIN.
Delete Supervisor(s) or User(s)
Note:
A User can only be deleted by the person who created the
User (i.e., the Master User or the Supervisor). If a Supervisor
is deleted, all Subordinate Users added by that Supervisor will
automatically be deleted.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
