29
To delete a User or Supervisor, complete the following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Press
Enter
and then
4
. Simultaneous green and red flashes display.
3.
Enter the Master User combination or the Supervisor combination.
Simultaneous green and red flashes display.
4.
Enter the User ID or Supervisor ID to be deleted. Simultaneous green
and red flashes display.
5.
Enter the User ID or Supervisor ID to be deleted again for verification.
Simultaneous green and red flashes display.
6.
If additional Users or Supervisors are to be deleted, repeat Steps 4-5
until all users have been deleted.
7.
Enter
00
. Simultaneous green and red flashes display.
Enable/Disable Lock Access For Subordinates
Note:
In Supervisory/Subordinate mode, only a Supervisor can
enable lock access for Subordinate User(s).
The Supervisor must complete the following steps to enable/disable lock
access for Subordinate User combination(s):
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Enter the valid Supervisor combination. Simultaneous green and red
flashes display.
3.
Enter the two-digit Supervisor ID of the Supervisor to whom the
Subordinate Users you want to enable/disable are assigned. For
example, if the Subordinate Users you want to enable/disable are
assigned to Supervisor ID “02”, you would enter “02” to enable/disable
this group of Subordinate Users. Simultaneous green and red flashes
display.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
