36
Note:
The default factory audit mode enables all lock personnel
(Master User, Access Users, Supervisors and Subordinate
Users) to retrieve reporting information. However the Master
User can limit the capability to retrieve audit records to only
certain User IDs. Refer to “Change Reporting Capabilities” for
more detailed information.
Note:
The retrieve audit records operation requires an SA key that has
been initialized using the PC software to retrieve audit records.
To retrieve audit records, complete the following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Press
Enter
and then
8
. Simultaneous green and red flashes display.
3.
Enter the combination. Short red flashes begin to display. From the
time these flashes begin, you have 10 seconds to properly place and
hold the initialized SA key to the lock key reader. If you do not properly
hold the key to the lock key reader within the 10 second period, short
red flashes followed by three long red flashes display to indicate an
error and you will need to re-key the operation. If the SA key has not
been properly initialized, three long red flashes display.
Helpful Hint:
For Round housing lock models, press down on the
top of the key with your thumb, holding the key at an angle
against the key reader to ensure that the key makes proper
contact with the key reader. For Vertical housing lock models,
press and hold the key directly against the key reader.
4.
Ensure that the key remains connected to the key reader until the lock
has completed dumping the reporting data. Hold the key in the key
reader and turn the dial three or four times every fifteen seconds until
simultaneous green and red flashes display
indicating that the audit
data dump is complete. (This data transfer can take up to about 40
seconds.)
5.
If you have purchased the PC software for reporting capabilities, return
the key to the Auditcon PC to be read. Refer to the software documen-
tation for instructions on reading the reporting key.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
