Logon to the Cencon 4 System
The Cencon 4 startup window controls access to configuration settings and logon:
Cencon allows a user to logon using either an authorized Special Supervisor, Supervisor, or Dispatcher key.
Note
Key Box : Place the logon key in the left key position.
PCIO Key reader: Place your logon key only in position 0, 1 or 2.
To logon using a key, select Logon to Cencon with Key. If the key is recognized as valid, enter the password as requested.
Remember that this field is case sensitive and recognizes spaces as well as characters.
Note
You cannot logon to the system using a nickname, or a user ID. You must use the password specified for the key in the key reader. The key in the
key reader identifies the user trying to log onto the Cencon 4 System.
Hint
If a window is displayed indicating that the User ID doesn't pass authority check, first check to make sure that the appropriate key is in the reader
and that the reader is properly connected.
After a successful logon, the Cencon 4 Main Menu window is displayed. Some of the items in the below window may not be displayed on your system
depending on your user authority settings.
Page 49
Document # 2070.127 Rev. C 4/10 Cencon 4 Getting Started Guide
