Kaba Mas DKX-10, Installation Manual

Document Number 548.0418 Rev. AX — 02/2019 

17

4.  Install at least one of the stick-on cable guides in an appropriate position to restrain the cables.
5.  Route the cables through the cable guide that was just installed.
6.  Depending on the thickness of the door, additional cable guides may be necessary to ensure the cables are sufficiently

restrained. Install additional guides as needed, and route the LCD and generator cables through them to ensure that the
cables do not get routed through the “KEEP CLEAR” area, over the Zebra connector, or near where the geared end of the
dial hub will project through the dial ring cover.

Cable Guide Locators

Dial Ring Cover

11

 Installation of the Dial Ring Cover

1.  Align the dial ring cover with the dial ring so that the generator will seat into the five o’clock position and the four aligning

lugs align with the corresponding slots in the dial ring.

2.  Carefully slide the dial ring cover into the dial ring.
3.  Hold the dial ring cover in place and tighten the two dial ring cover mounting screws to the specified torque.

12

 Cutting and Installing the Spindle

1.  Ensure that the lock bolt is extended and remove the cam from the lock case.
2.  Slide the dial hub onto the spindle, turning the hub slightly to align the generator drive gear teeth. Hold the drive cam

assembly in place while installing the dial hub.

3.  Snug down one setscrew to hold the dial hub in place.
4.  Mark the spindle flush to the dial hub.
5.  Loosen the setscrew and remove the hub.

ALTERNATE METHOD:

 The hub may be left on instead of removed, and used as a vise to hold the spindle while cutting.

8.  Carefully cut the spindle so that it will be flush to the dial hub after installation.

CAUTION: 

The spindle should not extend past the dial hub once installed but may be recessed up to 1/32" below the sur-

face of the hub. If it extends past the dial hub, it must be filed to flush.
9. Remove all burrs from the end of the spindle.