4
I
NSTALLATION
Install the Lock
Warning:
Do not take the lock case assembly apart. There are no
field servicable parts inside lock case.
Complete the following steps to install
the lock:
1.
Insert a cable shield into the spindle
hole from the back side of the
container door. (See Figure 2.)
2.
Place the protective tube on the
tube retainer over the spindle hole
on the lock case. Make sure that
the flex cable is positioned on the
outside of the tube (Figure 3).
Caution:
Do not touch the silver
leads on the flex cable. This
could cause ESD damage.
3.
While holding the lock case
assembly, carefully guide the
end of the flex cable and the
tube through the container so
that they are easily accessible
at the outside of the container
(Figure 4).
4.
Hold the lock case assembly
tightly against the inside of the
container and mark the tube flush (to
within 1/16”) with the outside of the
container door for cutting.
5.
Guide the end of the cable and the
tube back through the inside of the
container.
6.
Remove the tube from the spindle hole
on the lock case and use scissors to
cut the tube just inside your mark.
Keep the cut as straight as possible.
7.
Place the tube back onto the tube
retainer on the lock case. Once again
be sure the flex cable is positioned on
the outside of the tube (Figure 3).
Figure 4 - Guide flex cable through
container
Figure 3 - Place tube on tube retainer
Figure 2 - Insert Cable Shield
