© 2006-2007 Kaba Mas Corporation. All rights reserved.
Product warranty information can be found at: www.kaba-mas.com
Kaba Mas Corporation
749 W. Short Street, Lexington, KY 40508 USA
Phone: (859) 253-4744 FAX: (859) 255-2655
Customer Service: (800) 950-4744
Figure 14
Figure 15
Figure 16
13. Move the follower forward until it
engages the cam post.
14. Screw through the follower
guide and chamber with the 4-40 x
3/8” screw to secure the follower
assembly. (Figure 14)
15. Insert the back mounting plates
with ridges inserted into the hole in
the mounting surface. (Figure 15)
16. Secure back mounting plates with 3-28 x 1/2” screws. (Figure 16)
******************************************************************************
For a Cross Throw Installation:
(See front of sheet for End Throw.)
8. Insert the bolt into the bolt guide. (Figure 17)
9. Place the cam (marked by a C on the back surface) onto the control
shaft, with the post closest to the bolt guide. (Figure 17)
10. Place the follower over the chamber and cam with the follower
legs engaging the bolt. (Figure 18)
11. Insert follower guide into the slot on the chamber and pivot the
follower guide down to position/retain the follower. (Figure 19)
12. Screw through the follower guide and chamber with the 4-40 x
1/2” screw, to secure the follower assembly. (Figure 20)
Figure 17
Figure 18
Figure 20
Figure 19
Figure 21
Figure 22
Figure 23
13. Insert the back mounting plates ensuring that the end tabs fit
under the adjoining plate. (Figure 21)
14. Secure back mounting plates with the two 3-28 x 1/2” screws.
(Figure 22)
Install Strike
(If Required)
1. Install the strike using the two chrome Phillips
head wood screws. (Figure 23)
2. Once adjusted, secure the center of the strike
with a third chrome Phillips head wood screw.
Install Batteries
1. Remove the two screws from
the battery panel and then
remove the panel. (Figure 24)
2. Install two fresh, high quality,
name brand (Energizer
®
or
Duracell
®
) CR-2 lithium batteries.
(Figure 25)
Note:
The negative end of the
battery should be inserted into
the battery cavity first.
3. While the lock is locked, turn the knob forcefully to adjust the KABA
logo to the horizontal position. (Figure 24)
4. Test opening of the lock with the default combination for the model
you are installing: Model CL10 - “5525”, Model CL20 - “111 12345”.
Battery Panel
Figure 24
+
+
-
-
Figure 26
Figure 25
Note:
For the Model CL10, you must test the lock by toggling
between locked and unlocked. To unlock, simply enter the default lock
user combination of “5525”. To lock the lock, enter the default lock user
combination of “5525”. Then press and hold the
key until the yellow
light
Y
displays.
5. Reattach the battery panel (Figure 26) and test the lock once more
with the default combination.
