14
ATTACH BACK COVER ASSEMBLY FOR TESTING
1. Install the back cover assembly with the two mounting screws in order to test
the operation of the lock.
Do not install the cover lock pin at this time.
Caution:
Take care to align the connectors and the baffl e to the hole in
the cover.
2. Verify the operation of the lock as described on the following page under
INSTALLATION COMPLETION CHECKLIST.
FINAL INSTALLATION OF THE BACK COVER ASSEMBLY
WARNING:
Failure to verify that the lock
is operational before installing the cover
lock pin assembly may cause a lock out
condition.
1. Open the lock. (See page 15 for
operating instructions.) Leave the bolt in
the fully retracted position and remove
the back cover assembly.
2. Insert the cover lock pin through the back
cover.
3. Install the cover lock spring and retainer
clip onto the cover lock pin. The “fi ngers”
of the retainer clip should be angled away from the cover lock spring, and the
retainer clip must be seated in the groove of the cover lock pin. (See Figure 32.)
Helpful Hint:
A small hammer and the cut off piece from the inner tube can
be used to install the spring and clip.
Caution:
Do not push the clip retainer past the small groove in the cover
lock pin. If the clip is not located in the pin groove, it can interfere with pulling
the bolt or prevent withdrawal of the pin for normal back cover removal.
4. Record the 6-digit lock serial number in a secure location if you are the
end-user. If you are not the end-user, allow the end-user to remove the serial
number sticker from the back of the lock when the container has been placed
in use.
5. Make sure the bolt is fully retracted and reinstall the back cover with the cover
lock pin in place.
Caution:
Take care to align the connectors, the baffl e to the hole in the
cover, and the cover lock pin to the keyhole slot in the bolt rack.
6. Tighten the mounting screws to the specifi ed torque.
7. After restoring the bolt to the extended position, verify that the cover lock pin is
fully recessed into the back cover. If not, gently wiggle the cover lock pin to
seat it.
Lock On Back
Cover Pin
Retainer
Clip
Cover Lock
Spring
Figure 32 - Back Cover Assembly
