15
INSTALLATION COMPLETION CHECKLIST
1. Does the dial turn freely without scraping or binding?
2. Have all screws been securely tightened?
3. Operate the lock using the preset factory combination of 50-25-50. See
the
following section:
OPEN AND CLOSE THE X-09
.
OPEN AND CLOSE THE X-09 (
FACTORY COMBINATION
)
CW=Clockwise;
CCW=Counterclockwise
Note:
The viewing angle of the LCD is restricted from either side as a
security feature of the lock. This feature restricts viewing of combination
dialing by the casual observer. The display may also appear slightly more
dim than previous versions of the X-0 series of locks.
TO OPEN THE LOCK (using the Factory Combination):
1.
Dial
left
(CCW) until lock is “powered”. The lock is considered “powered” when
numbers appear on the LCD display screen.
2.
Continue dialing
left
(CCW) to the fi rst number of the factory combination,
50.
Stop on 50 and pause briefl y.
3.
Dial
right
(CW) to the second number of the factory combination,
25
. Stop on
25 and pause briefl y.
4.
Dial
left
(CCW) to the fi rst number of the factory combination,
50.
Stop on 50
and pause briefl y.
5.
Dial
right
(CW). After
OP
with a right arrow (
OP
en right) is displayed, dial to the
right to retract the lock bolt.
Note:
If at any time the dial remains stationary for more than 40 seconds,
the lock will reset (LCD will go blank) requiring the operator to redial the
entire combination.
TO CLOSE THE LOCK:
1.
Turn Dial to the
left
(CCW) a minimum of one complete revolution to extend
the bolt.
2.
Turn Dial to the
right
(CW) a minmum of one complete revolution to ensure that
it is locked.
Note:
The Dial should turn freely in either direction without catching or
binding when the bolt is extended and the container is locked.
