Kaba Mas X-10, Installation Instructions Manual

8

InsTallaTIon of generaTor Cable and Cable guIdes

1�  Place the generator cable into the dial ring housing recess containing a post 

used for positioning the cable� (See diagrams in Appendix B�) The hole in the 

cable must be positioned over the post on the dial ring, and the five gold tabs 

must be visible�

2�  The Zebra connector and Zebra connector housing are assembled at the factory 

but may come apart during shipment� If so, insert the Zebra connector into the 

Zebra connector housing before proceeding�

CAUTION: 

The Zebra connector is an electrical 

connector. Keep it clean!

3�  Place the Zebra connector  and connector 

housing over the generator cable, and press 

it into the recess� The hole in the Zebra 

connector housing must be positioned over 

the post in the dial ring� Be sure the black 

Zebra connector housing is positioned as 

shown in Figure 14� 

4�  Install at least one of the stick-on cable 

guides in an appropriate position to restrain 

the cables� (See Figure 15 for possible locations�)

5�  Route the cables through the cable guide that was just installed�

figure 13 - lCd and ZIf Connectors

figure 14 - Zebra assembly