Kaba Mas X-10, Installation Instructions Manual

10

6�  Remove spindle screw and spindle from lock case prior to cutting� Carefully cut 

the spindle so that it will be flush to the dial hub after installation.

Caution: 

The spindle should not extend past the dial hub once installed but may 

be recessed up to 1/32 inch below the surface of the hub. If it extends past the 
dial hub, it  must be filed to flush. (See Figure 18.)

7�  Remove all burrs from the spindle�

InsTallaTIon of The dIal 

hub and dIal

1�  Slide the spindle into the lock case� 

Note that the square portion of the 

spindle must be aligned with the 

square hole in the lock case� Insert 

spindle screw and tighten� (For torque 

specifications, see Page 1.)

2�  Apply lubricant to the hub bearing 

surface� (See Figure 19�)

3�  Make a bend in the dial hub locating 

gauge at its midpoint� This will keep it 

from acting as a spring as the hub is 

positioned for locking to the spindle�

4�  Place the Dial Hub Locating Gauge 

over the spindle and between the dial 

hub and the bushing in the dial ring 

cover� This sets up an initial 0�010 

inch end play� (See Figure 20�)

5.  Tighten the inner setscrew first. Now 

SECURELY tighten the setscrews in 

the dial hub to 17-20 inch-pounds of 

torque (a minimum of 1 inch deflection 

of the handle of the hex key)� 

6�  Remove the dial hub locating gauge�

Spindle flush to 
hub or recessed 
up to 1/32

"

figure 18 - spindle flush

or recessed 

figure 17 - mark spindle flush to hub 

Figure 19 - Apply Lubricant to Hub

Figure 20 - Place Gauge Between  

Dial Hub & Bushing