Kaba Mas X-10, Installation Instructions Manual

11

Caution: 

Tighten in a downward motion in case the hex key should break. (See 

Figure 21.)

7�  Apply lubricant to the retaining ring on the dial hub� Position the retaining ring 

so an equal amount of lubricant is consistently exposed around the hub� Also, 

apply grease from the lubricant tube to the entire ramp area just inside the back 

of the dial and to the inner surface of the 5-sided formed clutch spring within the 

dial� (See Figures 22 and 23�) 

Note: 

Ensure the “C” clip is located in the grove closest to the set screw. The 

retaining ring gap should be aligned with the setscrews so an equal amount of the 
retaining ring is exposed around the hub. The dial should slide easily into place on 
the hub without interference from the retaining ring. (See Figure 24.)

8.  Ensure that the 5-sided flat spring is fully recessed in the dial with the spring 

gap aligned with the internal key of the dial� (See Figure 25�)

9.  Carefully align the dial so the 5-sided formed spring matches the flats of the dial 

hub assembly� Holding the dial square to the spindle, apply pressure to the dial 

until the retaining ring seats in the dial� (See Figure 26�) 

Note: 

You should not be able to pull the dial away from the dial hub assembly. 

figure 23 - apply lubricant

Inside dial

figure 22 - apply lubricant to

ret. ring

figure 21 - Tighten setscrews

Setscrews

Retaining Ring Gap

figure 24 - align retaining ring