Kaba Mas X-10, Installation Instructions Manual

5

InsTallaTIon

prelImInary loCK InsTallaTIon

1�  Deburr spindle hole and opening�

2�  Feed Lock Cable through spindle hole� 

3�  Loosely attach the lock case to the 

container wall with the four mounting 

screws� 

4�  Tighten the lock case mounting screws 

to hold the lock case in place� (See 

Figure 5�)

CuTTIng The Tubes 

Warning: 

The end of the large tube that is to be discarded must be from the plain 

(unflared) end of the tube. The end of the small tube that is to be discarded must 
also be from the plain (unnotched) end of the tube.

1�  Make sure that the outer tube is properly placed over the lock case 

tube retainer�

2.  While holding the outer tube firmly in its seated position, use a 6 inch scale or 

ruler to measure 5/16 inch from the 

container wall and mark the outer tube 

at this length�

3�  Remove the lock case from the 

container and remove the outer tube for 

cutting�

4�  Assemble the saw blade and wooden 

saw handle provided� To assemble the 

saw, grip the saw frame in a vise, just 

below the neck� Drive the handle fully 

onto the neck� (See Figure 6�) This will 

reduce the tendency of the handle to 

turn on the saw frame when sawing�

Note: 

This saw is intended only for cutting  

the tubes. A standard hacksaw should  
be used to cut the spindle.

5�  Insert the tube into the rubber vise 

clamp (provided), with the mark just 

beyond the clamp. Then firmly clamp 

the rubber vise clamp in a vise� (See 

Figure 7�) Use the saw to cut the tube 

where marked� 

figure 6 - assemble saw

figure 7 - Cut Tube using Vise

figure 5 - Tighten

mounting screws