Revision level 11.02.2016
Page 3 of 3
Mounting instructions 71111 President A
– 71113 President
5. Technical Data
Lift height of bolt 12 mm
Bolt in fully extended position: approx. 14 mm
Bolt width: 25,4 mm; Bolt height: 12,6 mm
The maximum allowable force acting on the key bolt against the blocking direction, the maximum locking force and the
lateral load acting on the bolt, correspond to 1 KN and should not exceed this value. Provision should be made design
wise for bolt stoppers on both ends or for a bolt support.
The actuating turning moment on the key may not exceed 2.5 Nm
Mounting plate 3118000290
– reinforced by manganese steel – is available at option as a protection against opening by
boring.
Fixing of boltwork: via two bores on the front end (core borehole
3.3 mm) of the bolt head
Optional fixing of boltwork: two M4 threads (front end) or by means of a drift pin in the bolt head
The bolt was according to EN1300 with a permanent load of 2,5 N over 10.000 cycles tested. These load should not be
exceeded permanently.
