6
TM_ RegistrationUnits_201406_en.docx
1
About this Document
The following registration units can be used in a range of Kaba system solutions (Kaba exos,
B-COMM, KEM):
Product name until 2014/06/30
Product from 2014/07/01
Registration unit 90 04
Registration unit RFID
Registration unit RFID PIN
Registration unit Print RFID
Registration unit LA-PC
Registration unit LA-PP
Bolt Handle for IT Cabinets
Kaba registration unit 90 04
Kaba registration unit 90 01
Kaba registration unit 90 02
Kaba registration unit 90 00
Kaba registration unit 90 03
Kaba registration unit LA-PP
Bolt Handle for IT Cabinets
This document describes the mounting and installation of registration units. The instructions should be
followed consistently to ensure fault-free and safe application.
All drawing dimensions in millimeters (mm).
1.1
Validity
Compatibility between registration units and control units (reading devices) is described in Chapter
3.2.1 on page 13.
1.2
Target Group
This manual is only intended for specialist personnel.
The descriptions require personnel trained by the manufacturer.
The descriptions do not replace product training.
A service person is a person who has appropriate technical training and experience, which is required
in order to be aware of the risks which they or other people are exposed to when carrying out this work
as well as to keep the risks for themselves and other people as low as possible. It is the responsibility
of the service person to ensure compliance with the conditions stated by the manufacturer, as well as
applicable regulations and standards, when conducting this work.
This document is also used for information for people undertaking the following work:
Project planning and project implementation
Commissioning of the product within the network
Connection of the product to the user software by programming customer applications
Customer specific adjustment via parameterization of the product
NOTICE
For reasons of device safety, the actions described in this document for installation, maintenance and
servicing may only be carried out by a service person in accordance with EN 60950-1 (Information
Technology Equipment
– Safety).
