Basic safety information
TM_ RegistrationUnits_201406_en.docx
9
2
Basic safety information
The devices are constructed in accordance with the state of the art and recognized safety rules.
Despite this, handling this product may present sources of danger for persons and valuables.
Read and observe the following safety information before you use the product.
2.1
Intended usage
The devices and system are only intended to be used as outlined in the chapter Product description.
Any type of usage beyond the scope of this is not considered to be intended usage. The manufacturer
shall accept no liability for damage resulting from this unintended usage. The user/operator alone shall
bear the associated risk.
Only service persons may carry out the mounting and installation of a device; see Chapter 1.2, page 6.
Installation may only be carried out at locations that fulfill the climatic and technical conditions specified
by the manufacturer.
Kaba GmbH shall not accept liability for any damage that occurs as a result of improper handling or
incorrect installation.
2.2
Service and maintenance
Maintenance work/Correcting faults
Troubleshooting and maintenance work must only be performed by a service person; see Chapter 1.2,
page 6.
Modifications and alterations
Conversions and modifications of the device must only be performed by a service person; see
Chapter 1.2, page 6. Any conversions and modifications performed by other persons will result in a
complete exclusion of liability. Any modifications and alterations carried out by other persons will lead
to total exclusion of liability.
2.2.1
ESD protective measures
NOTICE
Danger to electronic components due to electrostatic discharge.
Improper handling of electronic PCBs or components may lead to damage that causes total failure or
sporadic errors.
General ESD protective measures must be observed when installing and repairing the device
The following rules must be observed:
Wear an ESD grounding armband when handling electronic components
Connect the end of the armband to a discharge socket or an unpainted, grounded metal
component. This will discharge static loads safely and effectively from your body
Only handle PCBs by their edges. Do not touch PCBs or connectors
Place any removed components on an antistatic surface or in an antistatic shielded container
Avoid contact between PCBs and articles of clothing. The armband only protects the PCBs against
electrostatic discharge voltage on the body; damage may still result from electrostatic discharge on
clothing
Only use electrostatically shielding and conductive protective bags to transport and ship modules
that have been removed
2.2.2
Environmental Hazards
