A
Assemble the key cylinder (D) in the rear of the
outside housing, and secure it using the bridge
(E) and two 8-32 x
9
/
16
” (14mm) Phillips
screws (F).
Install the tailpiece (G) horizontally in the cylin-
der, and secure it with the retaining clip (W),
using an external ring plier.
C
Break off the tailpiece at the mark using two
pairs of pliers.
B
Hold the outside housing against the door. The
tailpiece should extend between
1
/
4
” and
5
/
8
”
beyond the rear face of the door. Mark the tail-
piece accordingly.
V
PREPARE THE MECHANICAL OVERRIDE
7 1 0 - I I / 7 4 0 S E R I E S I N S TA L L AT I O N G U I D E • P K 2 7 1 0 / 0 8 / 0 2
P a g e 7
2
Removable Core Cylinder Mechanical Override
1
Key-in-Knob Mechanical Override
If you have an electrical override lock, continue on page 8.
A
Hold the outside housing against the door. The
tailpiece should extend between
1
/
4
” and
5
/
8
”
beyond the rear face of the door. Mark the tail-
piece accordingly.
B
Break off the tailpiece at the mark using two
pairs of pliers.
C
Install the key cylinder from the front of the out-
side housing, using the control key.
1
/
4
” to
5
/
8
”
(6.3 to 16mm)
W
G
F
E
D
1
/
4
” to
5
/
8
”
(6.3 to 16mm)
