• Only the Master user can perform this function.
Step 1: Ensure that the lock is in factory mode; if not, reset the lock as per
instructions in the respective Operations Manual to hard reset the lock
to factory default mode.
Step 2: Enter the lock programming mode using the factory Master PIN:
#12345678#
Step 3: [Skip this step for Storeroom (07) locks].
For a Residence (08) or a Privacy (15) lock, enter the command “013#”
to tell the lock that it contains a privacy thumbturn.
Then flip the thumbturn once & verify the Green LED flashes once.
Step 4: Finally enter another command code to actually define the lock’s
operating lock function as - Storeroom lock (07), Residence Lock (08)
or Privacy lock (15); enter only one of the three lock function command
codes (07, 08 or 15):
011# 15#
for Privacy lock, or
011# 08#
for Residence lock, or
011# 07#
for Storeroom lock [for E-Plex 2xxx/5xxx locks
only]
Step 5: # To end this lock programming session
* From now on the lock will perform as setup here as a Privacy lock, a
Residence lock, or a Storeroom lock etc. At this point, the Master
PIN is still the factory default of 12345678, which must be changed
to actually use the lock.
Step 6: Change the factory default Master PIN from 12345678 to any other 8
digit number for further programming as described in the Operations
manual.
For Technical Assistance Please Call
1-800-849-TECH (8324) or 336-725-1331
Kaba Access & Data Systems Americas
2941 Indiana Avenue Winston-Salem, NC 27105 USA
Tel: (800) 849-8324 (336) 725-1331
Fax: (800) 346-9640 (336) 725-3269
www.kaba-adsamericas.com
PKG3109 0214