Using the E-Plex Advanced ACS Software
E-Plex Advanced ACS User’s Guide
PKG 3114 0106
3–3
•
Card ID
Optionally, you can also assign a Prox Card for the Master here, in which case the
Master has to use dual credential (PIN and Prox Card) every time to program the lock
at the lock keypad.
•
Wiegand Bit Format for Prox Cards (applies to E-Plex 5700 locks only)
Select the appropriate
Wiegand Bit Format for Prox Cards
that you are using in
your system. The default value is
Standard Format (26-Bit)
. If you select the non-
standard
Other Format (27 to 84-Bit)
, you must use the Prox Card Reader/Enroller
to assign Prox Cards for the users. In this case, the display of the card ID format in
the Users dialog menu will not be in standard xxx-yyyyy format, but will display as a
long hexadecimal number only.
•
Prox Enroller (applies to E-Plex 5700 locks only)
By default, the
Prox Enroller Connected
field is not selected. You must select this
field only if you have the Prox Reader/Enroller device attached to the PC.
•
User PIN Length
Select the appropriate global
User PIN Length
—between four and eight digits—that
you will be using in your system. The default User PIN length is four digits.
•
Time Format and Daylight Savings Time (DST)
Select the display of
Time Format
for your system. The default is
12-Hour Time
(a.m. and p.m. display), and the other option is
24-Hour Time
display.
The E-Plex Advanced ACS software will use the start and end dates/times of the
DST setup (if enabled) directly from your PC’s operating system. It will automatically
send this information to the locks via the M-Unit, so that the DST switching in the lock
will occur automatically.
•
Default Path for Backup
This field defines the default directory path to be used when backing up system data
files. You may change the backup path to a CD-RW drive, network drive, or another
similar type of drive.
•
Default Path for Reports and PC Activity Log
This field defines the default directory path to be used when generating and saving
reports and archived data files. You may change the path for reports to a CD-RW
drive, network drive, or another similar type of drive.
2. Once you have updated the desired fields, click
Save
. The software verifies whether any
doors are affected and need to be re-programmed.
3. Click
OK
. The software confirms that the changes saved successfully and prompts you
for further changes.
4. Click
Yes
. The software closes the
System Setup
menu window.
Summary of Contents for E-Plex 5200
Page 1: ...Advanced ACS Software User Guide...
Page 36: ...Getting Started 2 26 PKG 3114 0106 E Plex Advanced ACS User s Guide...
Page 112: ...Operating the E Plex Lock at its Keypad 4 10 PKG 3114 0106 E Plex Advanced ACS User s Guide...
Page 128: ...Programming and Auditing Locks 5 16 PKG 3114 0106 E Plex Advanced ACS User s Guide...
