Using the E-Plex Advanced ACS Software
E-Plex Advanced ACS User’s Guide
PKG 3114 0106
3–29
If a Prox Card Reader is not connected:
3. From
the
User Group
drop-down list, select a user group.
4. In
the
Last Name
field, re-type the last name of the user.
5. In
the
First Name
field, re-type the first name of the user.
6. From
the
User Type
drop-down list, change the user type. Refer to
Lock User
Personnel Classifications
in Chapter 1,
About the E-Plex Advanced ACS
.
7. In
the
User PIN
field, re-type a four- to eight-digit PIN for the user.
Note:
A User PIN is pre-designated by the software based on your System Settings.
You may override the assigned PIN and enter a number of your choice.
8. For E-Plex 5700 lock users only, select the
Assign Prox Card
check box. For E-Plex
5200 lock users, proceed to step 11.
9. Click
the
Card ID
field to place the cursor there, so that the Prox Reader is ready to read
the Prox Card ID of the user.
Note:
The
Card ID
field is only available if you select the
Assign Prox Card
check box
for the E-Plex 5700 in the field.
Caution:
The
Card ID
field should not be entered manually. It must be read from the
Prox Card via the Prox Reader/Enroller attached to the PC. For manual card ID entry,
you must do it under the
Batch Enroll
sub-menu selection.
10. Place a flat side of the Prox Card on or in close proximity to the Prox Reader.
The
Card ID
field will display the card ID, and the Prox Reader will display a green light
once the card is successfully read.
Note:
Be careful to present the Prox Card quickly so that it is read only once.
11. Click
Save
. If no door groups were affected, the software alerts you.
Summary of Contents for E-Plex 5200
Page 1: ...Advanced ACS Software User Guide...
Page 36: ...Getting Started 2 26 PKG 3114 0106 E Plex Advanced ACS User s Guide...
Page 112: ...Operating the E Plex Lock at its Keypad 4 10 PKG 3114 0106 E Plex Advanced ACS User s Guide...
Page 128: ...Programming and Auditing Locks 5 16 PKG 3114 0106 E Plex Advanced ACS User s Guide...
