Kaba EX3600, Operation Manual

16

Required User Level: Master, Manager

1.   Put the lock into LearnLok

TM

 Pushbutton Programming Mode. -> 

# Master PIN (or        

Manager credential) #

2.   Enter command 

100#

 to add / modify a User Access Credential.

3.    Enter the User ID location NNN followed by # - 

NNN#

, we use 

023#

 for example 

(Range = 001 to 300). 

4a.   Card Only Mode:  After 100# 023# entry, 

present this user’s card

 close to the 

(black) card reader of lock; the 

green LED flashes

 indicating that the card has 

been enrolled (added); enter 

#

 which confirms that this user is not assigned a 

PIN.  You can add more cards by entering the next user’s ID location (NNN#) 
followed by presenting this next user’s card and then #; add up to 300 cards, if 
desired.

      Enter a last # to indicate the end of the programming.

       Example of Complete Entry for user ID=023:

100#023# Present card # # .

4b.   PIN & Card Mode:  Procedure is similar to step 4a above, but after enrolling the    

card you must not enter the # but continue with assigning the user’s PIN (4 to    

8 digits as configured initially).

Example of Complete Entry for user ID=023 and PIN=1234:

100#023# Present card (no # entry here) 1234# 1234# (to re-confirm) # .

In the first example above, this user’s card will open the lock with PIN assigned    

(card only mode), or in the second example above, the lock will open on         

entering the PIN first (1234) followed by presenting the associated card (PIN &    

  card 

mode).

PROCEDURE 2B -  ADD / MODIFy A MANAGER USER CREDENTIAL

The procedure to add a Manager user is exactly the same as adding a regular Access user 
except for the different 3-digit command code 

101

 (instead of 100) usage.  Also, only the 

Master can add, delete, etc, of the Manager users.

Required User Level: Master

1. Put the lock into “LearnLok

TM

” Pushbutton Programming Mode.

2. Enter command 

101#

 to add / modify a Manager User’s Access Credential

3.  Enter the User ID location NNN followed by #: 

NNN#;

 we will use 015# for 

example (Range = 001 to 300)

4a.  Card Only Mode:  After 101# 015# entry, 

present this Managers card

 close to 

the (black) card reader of the lock; the 

green LED flashes

 indicating that the 

card has been enrolled (added); enter # which confirms that this manager user is 

not assigned a PIN.  You can add more cards by entering the next user’s ID loc- 
ation (NNN#) followed by presenting this next manager user’s card and then #; 
add up to 300 cards, if desired.

Enter a last # to indicate the end of programming.

Example of Complete Entry for manager user ID=015

101# 015# Present card # # .