PK3520_09_07 • REMOTE ACCESS CONTROLLER - 660G XT
9
Determine the routing needed for the wiring of the 660G XT
peripherals (keypads, locking mechanism, etc) and as required
select the knock-out(s) on the controller box to remove for
installation of the strain relief(s).
To remove the selected knock-out(s), from the inner side of the
controller box, use a hammer and screwdriver, and tap out the
small metal disk.
Noting the amount of wires to route into the desired location,
insert the appropriate strain relief based on the diameter
required and secure with the locking nut as shown in figure 8.
Route all wires of the peripherals and power cables, into the
controller box (A), leaving some extra length for subsequent
steps. Tighten the compression nut of the strain relief (Z) and
pull on the wires to ensure the desired strain relief effect is
obtained.
CAUTION: Do not plug the power adaptor into the AC
outlet before the end of installation.
!
4.2 Installation Procedures
Step 5: Mounting the controller box
1. With proper tools, install the control panel in the desired
location, using the screws, washers and required
anchors in the hardware bag.
Figure 9
A
W
X
Y
or
AB
NOTE:
For easier access it is recommended to remove the
access panel before installation. If needed, keep it
nearby to refer to the wiring label or refer to Annex A
at the end of this manual.
CAUTION: Wire routing must be according to any local
building codes or legislations.
!
2.
Two types of power adaptors are available depending on
the country where the controller box is to be installed.
•
(N) For international applications;
mainly Europe, UK or Australia using 220 VAC to
240 VAC, 50-60 Hz
or
•
(O) For North American applications using
120 VAC, 60Hz
CAUTION: The following steps are to be done after the
appropriate power adaptor is selected, cables routed
through the strain relief and secured by tightening the
strain relief's compression nut, as per step 3.
!
International power adaptor (N)
1.
Prior to installing the International power adapter (N),
select the appropriate AC outlet prong from the set
depending on the standard AC power source inlet in the
country where the controller box is being installed.
2.
Fix the selected prong outlet on the International power
adapter (N).
3.
Out of the controller box
, route the wires to the AC
power source and secure the wire (recommended with
tie wraps).
4.
In the controller box
, using the crimp fork terminals
(AD) from the hardware bag and a crimp tool, crimp the
fork terminals to the end of each wire.
5.
Connect the fork terminated wires to the power supply (B)
inputs as shown in Annex A, Table 4.
North American power adaptor (O)
1.
In the controller box, connect one end of the fork-
terminated wires to the power supply (B) inputs, as
shown in Annex A, Table 4.
2.
Out of the controller box, route the wire assembly to the
AC power source and secure wire (recommended with tie
wraps).
3.
Using the crimp fork terminals (AD) from hardware bag,
crimp those at the end of the cable assy.
4.
Connect the fork-terminated wires to the power adaptor
screw terminals.
