Standalone operation with firmware option E300 V4
68
k4evo707en-2012-07
7.4.4
Input IN1 (s-module)
The input circuits listed below are valid for
IN1.
They can be connected as inputs with or without
line monitoring. It is possible to define both the line monitoring and the logic for the inputs on an
individual basis in the host system.
7.4.4.1 Inputs without line monitoring
7.4.4.2 Configuring
the
input
The standalone Compact Reader is equipped with a
self-learning function
. During initialization
(
INI reset
), the Compact Reader interprets the current switch position as the output position. If this
position is changed, the action defined under "activation" is performed. It is possible, therefore, to
use a make or break contact.
7.4.5 Output
OUT
An output
OUT
is available (e.g., an electric strike):
IMPORTANT
You must observe the maximum output capacity.
7.4.6
Electric strike connection
Access point side Designation
Connection/Function
Door
Output;
terminals 3, 4, and 5
Electric strike
Inside
IN1
terminals 6 and 7
Door opener key/door handle contact (REX)
