15
Set the Re-Lock and Wrong Try Limit and Penalty Times
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User
Enter the Master User or Manager User combina-
or Manager User
tion. The lock will beep/flash the green LED on
combination
each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/
flash of the green LED followed by the red LED, and
all digits of the combination must be re-entered. The
lock responds with three beeps/flashes of the green
LED to indicate available entry. If the combination is
not valid, the lock responds with three beeps/flashes
of the red LED.
3.
Press then 10.
Before re-lock time expires, press (Enter key)
followed by the 1 key and then the 0 key. The lock
responds with two beeps/flashes of the green LED.
4.
Enter two-digit
Enter a new two-digit re-lock time in the range of
re-lock time.
02-20 seconds. The lock responds with two
beeps/flashes of the green LED.
5.
Enter one-digit
Enter a new one-digit wrong try penalty limit in
wrong try penalty.
the range of 3-9 tries. The lock responds with two
beeps/flashes of the green LED.
6.
Enter two-digit
Enter a new two-digit wrong try penalty time in
wrong try penalty
the range of 00-20 seconds. The lock responds
time.
with two simultaneous beeps/flashes of the green
and red LEDs.
The re-lock time and wrong try limit and penalty
time are now in effect.
14
Step
Detailed Instructions
5. Enter Master User
Enter the new Master User combination again for
combination
verification. If the combination was verified suc-
again.
cessfully, the lock responds with two simultaneous
beeps/flashes of the green and red LEDs. The lock
responds with two beeps/flashes of the red LED to
indicate an error.
The lock is now activated and the new Master
User combination is in effect.
Activate the Manager User
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User
Enter the Master User combination. The lock will
combination.
beep/flash the green LED on each keystroke
entered. If the
Clear key is pressed during data
entry, the lock responds with one beep/flash of the
green LED followed by the red LED, and all digits of
the combination must be re-entered. The lock re-
sponds with three beeps/flashes of the green LED
to indicate available entry. If the combination is not
valid, the lock responds with three beeps/flashes of
the red LED.
3.
Press then 90.
Before re-lock time expires, press (Enter key)
followed by the
9 key and then the 0 key. The lock
responds with two beeps/flashes of the green LED.
4.
Enter Manager
Enter the combination for the Manager User. The lock
User combination.
responds with two beeps/flashes of the green LED.
Note: When PIN length = 0, Combination = User ID only; otherwise,
Combination = User ID + PIN.
5.
Enter Manager
Enter the Manager User combination again for
User combination
verification. The lock responds with two simulta-
again.
neous beeps/flashes of the green and red LEDs if
the combination was verified successfully. The lock
responds with two beeps/flashes of the red LED to
indicate an error.
The Manager User is now activated with the entered
combination. If PIN length is not 0, the PIN should
be changed immediately for security purposes.
