19
Step
Detailed Instructions
3.
Press then 50.
Before re-lock time expires, press (Enter key) followed by the 5 key and
then the 0 key. The lock re sponds with two beeps/flashes of the green LED.
4.
Enter User’s new
Enter the new Manager User or Keypad Access User com bi na tion (User ID
combination.
+ new PIN). The lock re sponds with two beeps/flashes of the green LED if
the combination was verified suc cess ful ly. The lock responds with two
beeps/flashes of the red LED to indicate an error.
5.
Enter User’s new combination
Enter the Manager User or Keypad Access User combination again for
again (User ID + new PIN).
verification. The lock responds with two si mul ta neous beeps/flashes of the
green and red LEDs if the com bi na tion was verified suc cess ful ly. The lock re -
sponds with two beeps/flashes of the red LED to indicate an error.
The new PIN is now active for the user.
Change Key Access User PIN
Note: This operation is only applicable if PIN length is not 0.
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Insert Access User Key into
Insert the Access User Key into the lock key reader. The lock responds with
key reader.
two beeps/flashes of the green LED.
3.
Enter Key Access User PIN.
Enter the four-digit PIN for the Key Access User. The lock responds with
three beeps/flashes of the green LED to indicate available entry. If the lock
PIN is not valid, the lock responds with two beeps/flashes of the red LED.
(Note: For a User who has not changed the default PIN, the lock will not open.)
4.
Press then 51.
Before re-lock time expires, press (Enter key) followed by the 5 key and
then the 1 key. The lock re sponds with two beeps/flashes of the green LED.
The lock re sponds with two beeps/flashes of the red LED if the opener was
a Keypad Access User or a Key Access User that does not require a PIN for
lock access.
5.
Enter new PIN.
Enter the Key Access User’s new PIN. The lock re sponds with two beeps/
flashes of the green LED. The lock re sponds with two beeps/flashes of the
red LED to indicate an error.
6.
Enter the new PIN again.
Enter the Key Access User’s new PIN again for verification. The lock
responds with two si mul ta neous beeps/flashes of the green and red LEDs.
The lock re sponds with two beeps/flashes of the red LED to indicate an error.
The new PIN is now active for the Key Access User.
Change Master User Combination (User ID + PIN)
Note: The new User ID that is selected must be an available ID (one that has not already been selected for another
user).
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User
Enter the current Master User combination. The lock will beep/flash the
combination.
green LED on each key stroke entered. If the Clear key is pressed during
data entry, the lock responds with one beep/flash of the green LED fol lowed
by the red LED, and all digits of the com bi na tion must be re-entered. The
lock responds with three beeps/flashes of the green LED to indicate avail-
able entry. If the combination is not valid, the lock responds with three
beeps/flashes of the red LED.
Summary of Contents for PowerLever 455 Series
Page 1: ...PowerLever 455x Operating Instructions...
Page 37: ...37 Notes...
Page 38: ...38 Notes...
Page 39: ...39 Notes...
