25
Disable a Keypad User
Note: This operation is used to disable lock access for either Keypad Access Users or Service Users.
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User or a
Enter the Master User or a Manager User combination. The lock will beep/
Manager User combination.
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
fol lowed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the com bi na tion is not valid, the lock re sponds with
three beeps/flashes of the red LED.
3.
Press then 70.
Before re-lock time expires, press (Enter key) followed by the 7 key and
then the 0 key. The lock re sponds with two beeps/flashes of the green LED.
4.
Enter Keypad User ID.
Enter the User ID of the Keypad User to be disabled. The lock responds
with two beeps/flashes of the green LED if the User ID is valid. The lock
responds with two beeps/flashes of the red LED to indicate an error.
5.
Enter Keypad User ID again.
Enter the Keypad User ID again for verification. The lock responds with four
beeps/flashes of the green LED. The lock responds with two beeps/flashes
of the red LED if the User ID was un con firmed, if the User ID was not in use,
or if the User ID was not that of a Keypad Access User or a Service User.
The Keypad User is now disabled.
6.
Repeat Steps 4–5 to disable
If additional Keypad Users are to be disabled, repeat steps 4–5 until all User
more Keypad Users or go to
until all User IDs are disabled. If no ad di tion al Keypad Users are to be dis-
step 7.
abled, go to step 7.
7.
Press .
Press (Enter key) to exit this procedure. The lock responds with two
si mul ta neous beeps/flashes of the green and red LEDs and exits this
procedure.
Enable a Key Access User
Step
Detailed Instructions
1.
Power lock.
Power the lock by depressing the outside lever.
2.
Enter Master User or a
Enter the Master User or a Manager User combination. The lock will beep/
Manager User combination.
flash the green LED on each keystroke entered. If the Clear key is pressed
during data entry, the lock responds with one beep/flash of the green LED
fol lowed by the red LED, and all digits of the combination must be re-
entered. The lock responds with three beeps/flashes of the green LED to
indicate available entry. If the com bi na tion is not valid, the lock re sponds with
three beeps/flashes of the red LED.
3.
Press then 73.
Before re-lock time expires, press (Enter key) followed by the 7 key and
then the 3 key. The lock re sponds with two beeps/flashes of the green LED.
4.
Enter Key User ID.
Enter the four-digit User ID of the Key Access User to be enabled. The lock
responds with two beeps/flashes of the green LED if the User ID is valid.
The lock responds with two beeps/flashes of the red LED to indicate an
error.
5.
Enter Key User ID again.
Enter the four-digit Key User ID again for verification. The lock responds with
four beeps/flashes of the green LED. The lock responds with two
beeps/flashes of the red LED if the User ID was unconfirmed or if the User
ID was not in use.
The Key Access User is now enabled.
Summary of Contents for PowerLever 455 Series
Page 1: ...PowerLever 455x Operating Instructions...
Page 37: ...37 Notes...
Page 38: ...38 Notes...
Page 39: ...39 Notes...
