Kaba PowerLever PROX 9000, Quick Reference Manual

2

Lock Entry Methods

A lock can be opened using one of three different access methods:

PIN & PROX Card

PROX Card Only

PIN Only

Lock Operation

The PowerLever lock is designed to operate using internally-generated power. The
self-contained PowerStar

TM

 generator is triggered by depressing the outside lever.

One simultaneous flash of the green and red LEDs accompanied by a low volume
beep indicates that the lock is powered.

Operating Conventions

The following conventions apply to the operation of the lock:
•

Once the lock is powered, you must enter a valid PIN (combination) or present a
valid PROX Card within 10 seconds.

•

If a lock and user are set up for PIN and PROX access, the user has a maximum
of 5 seconds after entering a valid PIN to present the PROX Card.

•

The PROX Reader is located on the front of the lock just below the keypad.
When presenting a PROX Card, place a flat side of the card on or near the
PROX Reader.

•

To clear any uncompleted keypad entry, press the 

C 

(Clear) key.

•

To initiate a lock operation other than opening the lock, you must:
1)

Power the lock.

2)

If PIN is required, enter a valid PIN.

3)

If PROX Card is required, present a valid PROX Card.

4)

Before re-lock, press 

:

:

:

:

:

(Enter)

 followed by the 3-digit command code for

the lock operation. For example when adding an Access User, you would
press 

:

:

:

:

:

 and then

 100

.

•

When performing multiple passes within an operation for multiple access users,
the 

:

:

:

:

:

 key is also used as a terminator for the operation.